In the era of low-carbon and environmental protection, traditional building materials can no longer meet the requirements of the construction market, and new building materials are increasingly favored by the market. New building materials mainly include aerated blocks, lime sand bricks, fly ash bricks,

ALC plates, pipe piles, etc., in the production process of these new building materials, all need to go through the high temperature steam curing of the key equipment autoclave.

The steam required by the autoclave for steam curing of the aerated block is mainly supplied by the boiler, that is to say, in the autoclave curing process, the source of the heat in the autoclave is saturated steam, and the consumption of these heat is through

The following aspects: the heat required by the aerated block product itself, the residual air in the heating kettle, heating the mold and the steaming car, heating the condensed water in the kettle, and the autoclave body to dissipate heat to the space.

According to the introduction of the autoclave manufacturer Zheng Guo, in the production of blocks, the steam curing and thermophysical process of the autoclave are the necessary conditions for the product to obtain high strength and excellent performance. During the production process, the steam is eliminated.

For every cubic meter of aerated block, the amount of steam consumed by autoclave curing is 224kg.

In the aerated block production line, an autoclave and a boiler are inevitably used. Although the autoclave steaming is only one section, the autoclave is steaming.

Plays an important role in the process of pressure. Through the steam curing of the boiler and the autoclave, the aerated block produced is higher in strength, more stable in function and more consistent.

Meet the needs of customers in the market. Many people don’t know how to set up the output of aerated blocks, the length of the autoclave, and the tonnage of the steam boiler before the plant is built.

Matching, the following editor will give you one:

1. Equipment with an annual output of 300,000 cubic meters of aerated blocks:

10 φ2 68x31m autoclave + 10t/h steam boiler;

2. Equipment with an annual output of 250,000 cubic meters of aerated blocks:

8 φ2 .68x31m autoclave + 8t/h steam boiler;

3. Equipment with an annual output of 200,000 cubic meters of aerated blocks:

6 φ2.68x31m autoclave + 6t/h steam boiler;

4. Equipment with an annual output of 100,000 cubic meters of aerated blocks:

4 φ2 .68x31m autoclave + 4t/h steam boiler;

5. Equipment with an annual output of 50,000 cubic meters of aerated blocks:

2 φ2.68x31m autoclave + 2t/h steam boiler;